Dr. Pulley HIT Clutch 231801 - 250cc CFMoto or Kymco 250
Dr Pulley HIT Clutch for 250cc vehicles. Comes with 6 sets of springs for extra tuning ability!
Clutch Bell not included
Dr Pulley HIT clutches are one of the best on the market today!
What makes the Dr Pulley HiT (High-Thrust) Clutch so special and worth the extra cost?
The Dr Pulley HiT clutch has high-quality clutch pad material running the length of the clutch arms for maximum surface area engagement with the clutch bell. The stock clutches often only have a small patch of soft clutch pad material in the center of the clutch arms.
Additionally, the HiT clutch has a secondary mechanism that engages when your engine reaches a certain RPM (tunable with the included multiple sets of "pillow" springs). This secondary mechanism locks the clutch arms in place against the clutch bell minimzing clutch slippage when under load!
The result? Solid clutch engagement at all times, particularly when accelerating and climbing.
This clutch is designed to be tuned to your vehicle and comes with at least six sets of springs for all your tuning needs.
The Buggy Parts NW team highly recommends the Dr Pulley line and uses them in our own vehicles.
For Buggy owners, this product fits all buggies using a CFMoto 250 engine. All buggies with a high/low forward transmission such as the Hammerhead 250ss and Joyner Sand Viper 250 use this motor. Most all other 250cc buggies use the CN250 motor and use the Dr Pulley HiT Clutch product 241801.
For Scooter owners, the CFMoto 250 version we offer will work with the following brands (and more):
Important notice: If you have a CFMoto V3 or V5 engine in your scooter, please measure and verify the inner diameter (ID) of your clutch bell before ordering this product! Models of scooters with these engines with a 135mm ID Bell will use the HiT241801 clutch. Please check before ordering!
Kymco: Ego 250, Dink 250, People 250, XCiting 250
Clutch Outer diameter: 150mm - for use with 153mm clutch bell.
Center opening: Width - 28mm; Height - 24mm
This clutch will fit the Kinroad 300 buggy!